Team Powers Radon Pro V4 2S 200Amp Brushless ESC

Team Powers Radon Pro V4 2S 200Amp Brushless Electronic Speed Control

Includes:

• Speed Control w/ 12 gauge wires pre-soldered

• PC link programmer

• ESC to PC link cable

• USB to PC link adapter

• Sensor cable

• Double-sided servo tape

Features:

• Ultra-smooth, Precise Throttle and Braking Control

• Compatible with Sensored/Sensorless Brushless Motors

• Data Analysis Capability(RPM, Low voltage and ESC temperature)

• Easy PC Link Interface for Advanced Programming and Updating (wires and adapters included)

• Built-in one touch On/Off switch with LED

• Built-in Low voltage cut-off, Overheat protection and signal loss protection

Improvements based on Radon Pro V3:

Hardware:

• Upgraded higher amperage FET to low the hardware internal resistance

• Lower IR can lower the speed control operating temperature and increase output power

• Open case design allows the dissipation of more heat which lowers the speed control operating temperature by 6%

• The speed control height is only 17mm which is 2mm lower compared to the Radon V3

• Weight is ~6% lighter

• Supports Ch3/Ch4 Aux Input signal to control different item function values

• New PCB layout design with better stability and reliability

Software:

• Ch3/Ch4 Aux function to control one of the below pre-defined control item function (e.g. IP-Limiter, Throttle Rate, RPM Lock, Initial Brake, Drag Brake, Brake Force, I-BK-RSP, Brake Rate, Boost Timing, Boost Trig LVL, Boost Trig Rate, Turbo Timing, Turbo Delay, Turbo On Rate)

• Optimized brake function with smoother feel

Specs:

• Controls: Forward/Brake/Reverse

• Input Voltage: 2S-3S lipo

• BEC: 6V/7.4V selection/max ~5A

• Motor Limit: 4.0T or over

• Max current: ~200A per phase

• Size: ~38x30x17mm

• Weight: ~37g (not include wiring and fan)